How do I use the hookah

2021-12-27 15:27

1. Add water to the smoke bottle and cover the metal tube with 0.8-1cm. The water should not be too much, not more than 2CM, otherwise it will be difficult to suck.


2. Connect the metal pipe to the pot body, and then connect the pot body with the cigarette bottle.


3. Put the round smoke tray on the pot body and fix it.


4. Buckle the smoke bowl rope ring on the smoke tray, and then place the smoke bowl on the rope ring, and pay attention to the air seal; Do not use too much force when placing the ceramic smoke bowl or it will break.


5. Put a smoke pipe rope ring on the smoke pipe mouth of the pot body, connect the wooden end of the smoke pipe to the black rubber mouth, and pay attention to the air seal; If you have a multiple pipe, connect the other pipes in turn.


6, the water tobacco into the ceramic bowl, to keep the smoke smooth, pay attention to tobacco can not put too much too crowded; It is recommended to keep a little space between the top and the bottom of the tinfoil.


7, cut a square of tin foil to put the whole ceramic smoke bowl wrapped and pinched (to keep sealed), in the tin foil with toothpick or carbon clip on one end of some holes


8, with carbon clip a shisha special charcoal, with a lighter to burn the charcoal red; Note that the black part of the carbon is not burned at this time, you can use a straw to start breathing and spitting out, can accelerate the carbon burning through, but do not inhale into the lung.


9, cover the hood, if you enjoy the shisha in the open air, the hood can prevent the wind blowing charcoal dust.


10. Put the disposable nozzle on the pipe and try to take a few mouthfuls. At this point the carbon combustion may not be enough, can start to breathe and spit out, accelerate the carbon burning through, but do not inhale into the lung.


11. The air valve is used to prevent gas from entering the smoke bottle. When there is an idle smoke pipe mouth, the valve should be plugged with small steel balls.


name:
Message:
Verification code:
submit
Comment